多网口X86 router set up wg services. Key point

You must set up all ethernet card before set up WG and Mwan3 services.
if you just have only two ehternet card.You can just set up WG and Mwan3 services direcyly without set up ethernet card.
Because in default settings,My firmware only support 2 ethernet card.If your router have more than 2 ethernet card.You must activate your other ethernet card first before set up wireguard and Mwan3.

本文由 admin 创作，采用 知识共享署名4.0 国际许可协议进行许可
本站文章除注明转载/出处外，均为本站原创或翻译，转载前请务必署名
最后编辑时间为: Mar 23, 2021 at 12:37 pm